Quote:
Originally Posted by DtheP47
Try some "Hard Plastic Glue" from Wilkinsons Mick to stick the edges, use masking tape to support the assembly until it sets. Then use the new wonder moldable glue Sugru to reinforce the inner wall. Sugru has a short shelf life so check before you buy (Wilkinsons again) and go for the pack with the longest shelf life because that does affect its properties. As GB suggests give it a good clean first, acetone or nail polish remover. Good luck.
|
If you use normal PVC insulation tape with araldite the tape peels off the araldite when it's gone hard. You can use it to hold the glue where it would normally run off and to make fillets with the glue to give more strength to 2 glued pieces