Quote:
Originally Posted by Less
O.K. where to start? Well, what is a quote?
We use a quote when we want to refer to what someone has already mentioned or after finding something that was said out there on the www.
There are a few ways we can do it.
Method 1/ After reading what has been said in a post:-
|
Quote:
Originally Posted by Less
We can either press the  or the  Button in the bottom right hand corner of the box we are reading.
As we want to quote what has been said we will press the button |
Quote:
Originally Posted by Less
This gives us the whole of that post.
We might not want all of the post, so we can modify it.
Left click and hold at the beginning of the words you do not require and pass the cursor over them until all you wish to remove is highlighted in blue, they will then be removed, when you press the backspace key..
Below is the same post altered:-
Then make sure that the cursor is flashing after the
|
at the end of what you want and you can type your reply. Pretty easy?[/quote]
After a slapped wrist from Mick for being lazy...
Have read back and found less's lessons and can multiple quote one extra quote but then it seems to give error -but it is a start!
